Press Selection Guide

Press Selection Guide

There are several parameters of the press that need to be confirmed before the correct selection:

(1) Pressure: It is advisable that the pressure of the selected press-fitting product be 10% - 90% of the range of the machine;

(2) Opening height: it is the height from the working table when the indenter is at the top dead center; there is also a mold opening height, which is the top dead center of the press; there are also closed heights and strokes used together to determine the opening height of the press, The closing height is the bottom dead center of the press, plus the stroke is the opening height; for a unified understanding, we call it the opening height;

(3) Pressing stroke of the press: the distance that the indenter moves from the top dead center to the bottom dead center (because the full stroke of the press can be used for full-scale press-fitting, there is no empty stroke without additional force, so it is To improve work efficiency, it is not necessary to over-enlarge the stroke);

(4) The empty size of the working table of the press: it is appropriate to install the mold and place the workpiece conveniently;

(5) The mold installation mode of the press: the fixed mode at the upper and lower ends (usually the upper end uses a mold handle, and the T-slot is installed on the lower table) WORLD Press Machine official website www.pressmachine-world.com, please reprint Note the source!