How to make a press

How to make a press

The anti-vibration foot cup is installed on the base, and the base can be placed flat on the ground without shaking, and then the frame is installed; the frame is provided with a pressure head, an upper worktable and a lower worktable; the pressure head is movably set above the upper worktable, and the pressure head is connected to the guide rod , the guide rod is connected to the ball screw; the ball screw and the motor are connected by a synchronous belt drive; there is a pressure sensor on the pressure head, and the pressure sensor is electrically connected to the control panel; the right end of the control panel is provided with a start button and an emergency stop button from top to bottom. and reset button; the middle position of the upper worktable is provided with a lower backing plate, and the lower backing plate is provided with a positioning block; the left and right ends of the lower worktable are provided with supports, and each support is fixed with a press-fitting cylinder to press The mounting cylinder is connected to the piston, and the end of the piston rod is provided with a guide sleeve; the press-fitting cylinder is electrically connected to the motor; the middle position of the lower worktable is provided with a clamping mechanism, which is connected to the handwheel through a screw, and the pressure can be adjusted according to Processing requires replacement of parts, and has wide applicability. WORLD Press Machine official website www.pressmachine-world.com, please indicate the source for reprinting!