Basic operation process of press machine

Basic operation process of press machine

1. In the parameter setting state, press two buttons with both hands, the pressure head slides slowly, when any button is released, the pressure head is saved in the current position, continue to press, the pressure head continues to slide. When the two buttons are released at the same time, the pressure head Slide the head slowly back to its original position.

2. In the running state, as a trigger signal for equipment startup, in order to ensure safety and suitability for different production needs, the startup modes are divided into the following three types:

A: Two-hand trigger start, in order to ensure the personal safety of the operator, in the working environment with grating protection, set the electronic press to the two-hand trigger start mode, press the start button with both hands at the same time within 1 second, the electronic press Automatically start and complete a work cycle;

B: Both hands start continuously. In order to ensure the personal safety of the operator, in the working environment without additional grating protection, set the electronic press to the two-hand continuous start mode, press the start button with both hands at the same time within 1 second and press and hold the button for a long time. , until a working cycle is completed, if any button is released during the press-fitting process, the electronic pressure stops at the current position, and an alarm is issued;

C: Single-cycle press-fit mode; A and B start-up modes are used, and each time the equipment is started to complete a working cycle, this mode is suitable for press-fit connection of parts;

D: Reciprocating cycle test mode; when using this mode, the B start mode function must be turned off. In this mode, press the left button to start the device to start reciprocating to complete the same press-fitting procedure, and press the right button to complete the cyclic press-fitting operation. This mode is suitable for Product fatigue test;

3. In pressure calibration mode, press the left button to jog the pressure head downward, and press the right button to jog upward.

4. Emergency stop: It is used as an emergency stop in any state. In case of emergency, press the emergency stop button, the equipment will be in a suspended state, and the equipment cannot enter the next action. Only manually rotate the button counterclockwise to release the button. to operate normally. This article is from the official website of the manufacturer WORLD Press Machine www.pressmachine-world.com, please indicate the source for reprinting!