WORLD Press Machine introduces the production process of press machine

WORLD Press Machine introduces the production process of press machine

1. Materials required for the production of the press machine:

To produce a press, the materials that need to be prepared are: motor, driver, pressure sensor, base, body, guide column, guide rod, bearing, pressure head, finished mobile construction table, safety grating, start button, emergency Stop button, main switch power supply, operation touch screen, drive control, operation button box, electric control box, place shock-proof foot cup on the ground, and after all the materials are prepared, the production of the press can be started.

Second, the method of making a press machine:

The anti-vibration foot cup is installed on the base, and the base can be placed flat on the ground without shaking, and then the frame is installed; the frame is provided with a pressure head, an upper construction platform and a lower construction platform; the pressure head is movably set above the upper construction platform, and the pressure head is connected to the guide rod , the guide rod is connected to the ball screw; the ball screw and the motor are connected by a synchronous belt drive; there is a pressure sensor on the pressure head, and the pressure sensor is electrically connected to the control panel; the right end of the control panel is provided with a start button and an emergency stop button from top to bottom and reset button; the center of the upper construction platform is provided with a lower backing plate, and the lower backing plate is provided with a positioning block; the left and right ends of the lower construction platform are provided with supports, and a press-fitting cylinder is fixed on each support. The cylinder is connected to the piston, and the end of the piston rod is provided with a guide sleeve; the press-fit cylinder is electrically connected to the motor; the center of the lower construction platform is provided with a clamping mechanism, and the clamping mechanism is connected to the handwheel through the screw, and the pressure can be freely controlled and can be adjusted according to Finishing requires replacement of parts, and it has a wide range of applicability.



3. Precautions for pressing machine

The press is classified as an intelligent press-fitting equipment. In order to highlight the characteristics of the press, it is necessary to pay attention to the guide post, bearing, and mobile construction table for polishing and electroplating treatment. Do not scratch during production, you can wear gloves, and pay attention to the connection. Make smooth construction on the parts, maintain the environmental hygiene of the production site, and detect the installation tolerances of parts in time. As long as the above steps are followed, I believe that a press can be easily made.