Hydraulic shears operating rules and precautions

The hydraulic shearing machine is one of the most ideal sheet processing equipment. Its biggest feature is that it has complete functions. The following world press machine will introduce its relevant knowledge to you.

Hydraulic shears operating rules:

1. Start the shearing machine for several cycles of idling, to ensure that under normal conditions, try to cut sheets of different thicknesses, from thin to thick. Make sure the user is familiar with shearing machine performance.

2. Different blade gaps must be adjusted for different plate thicknesses during trial shearing. If the corresponding blade clearance is not adjusted, the blade durability will be affected.

3. Turn on the pressure gauge switch during the shearing process and observe the pressure value of the oil circuit. The user must abide by the oil circuit pressure regulations of the machine, and must not increase the pressure for the material surface that exceeds the specified value, causing damage to the machine.

4. The sound is balanced during operation. If the shearing machine is noisy, it should be stopped for inspection.

5. When the shearing machine is operating, increase the temperature of the fuel tank by 60 degrees, and shut down the machine to rest when it exceeds.

Precautions for the operation of hydraulic shears:

1. The staff must be familiar with the structure and performance of the hydraulic shearing machine. Before the operation, they should wear tight protective clothing, the cuffs should be fastened, and the hem of the top should not be opened. To prevent the machine from being strangled, you must wear a safety helmet.

2. Remember not to put your hand between the blades of the hydraulic shearing machine to avoid danger. In addition, all sundry tools must not be stored on the workbench to avoid accidents caused by rolling into the knife edge.

3. When the hydraulic shearing machine is running, the staff cannot leave the work place. When the hydraulic shearing machine is found to be abnormal, it is necessary to stop the operation in time and check the cause of the failure.

4. The thickness of the shearing material of the hydraulic shearing machine should be all kinds of steel plates, copper plates, aluminum plates and non-metallic material plates with the rated value of the machine tool, and must be materials without hard marks, welding slag, slag inclusion, and welding seams. Over-thickness, it is strictly forbidden to use hydraulic shears with overload. Do not cut quenched steel and hardened steel, high-speed steel, alloy steel, castings and non-metallic materials.

The above is the introduction of the world press machine, hoping to deepen your impression of the hydraulic shearing machine.