What are the Parts of a Power Press Machine?
Hydraulic press applicable process
by：WORLD
2023-06-04
1. After checking that there is no abnormality in the device, turn on the power supply, and the device enters the initial reset state. After the reset is completed, the device enters the standby state, and the three-color status indicator is green.
2. Put the workpiece to be pressed on the worktable.
3. Select the mold number to be pressed in the operation interface of the man-machine display; switch the selection button to the 'automatic/single cycle' mode, and then press the start button on the button box with both hands at the same time, the equipment starts to run; the three-color light is Yellow operating indication.
4. The pressure spindle starts to move at the set speed: fast down-detection-press-fit-buffer-pressure-holding-return.
5. After the press-fitting is completed, the three-color status indicator of the equipment turns green;
6. When the selection button is switched to 'manual' mode, that is, after the two hands are triggered to start, the hydraulic spindle goes down and stops when the hand is released. This action is mainly used for equipment debugging and initial alignment of the workpiece.
7. The state when the emergency stop button is pressed:
The three-color light is red; the buzzer continuously emits a short beep; the pressure spindle stops at the current position; press the 'reset' button, the pressure spindle of the equipment returns to the working origin and waits until the equipment is pressed again to start. This article is from the official website of the manufacturer WORLD Press Machine www.pressmachine-world.com, please indicate the source for reprinting!
Custom message
Related Products
