How to adjust the size of the shearing machine and its applicable method

The shearing machine is suitable for light industry, aviation, shipbuilding, metallurgy, instrumentation, electrical appliances, stainless steel products, steel structure construction and decoration industries. The following world press machine will briefly introduce how to adjust the size of the shearing machine and its applicable method.

How to adjust the size of the shearing machine?

1. First, determine the bending force and the size of the V-shaped groove opening of the lower die, which can be calculated according to the thickness of the sheet and the length of the folded sheet.

2. Align the center of the upper and lower molds and adjust the gap.

3. Determine the position and process flow of the front and rear stoppers, and switch according to the adjustment switch.

4. Place the workpiece in the middle of the hydraulic press brake table to measure the pressure.

5. Adjust the mold gap again, and adjust the upper mold adjustment block if necessary.

6. At the same time, ensure that all seals are completely sealed, and those with leakage should be replaced in time.

7. The rear gauge adjustment generally has electric quick adjustment and manual fine adjustment, the method is the same as that of the shearing machine.

8. Step on the foot switch to start bending, if the foot is released, it will stop working, and if you continue to step on the bending, it will continue.

How does the shearing machine work?

1. Adjust the gap of the blade according to the thickness of the material to be cut.

2. Adjust the template or fixture according to the width of the material to be sheared.

3. Before the operation of the shearing machine, make 1-3 empty strokes, and then the shearing work can be carried out after it is normal.

4. If it is found that the machine is not running normally during use, it should immediately cut off the power and stop it for inspection.

5. When adjusting the machine tool, the power supply must be cut off, and the safety of hands should be paid attention to when moving the workpiece.

6. All parts of the shearing machine should always be lubricated. The operator should add lubricating oil once in each shift, and the mechanic should add lubricating oil to the rolling bearing parts once every six months.

The above is an introduction to the size adjustment of the shearing machine and its applicable method.