Press manufacturing method

1. Raw materials

To produce a press, the materials that need to be prepared are: motor, driver, pressure sensor, base, body, guide column, guide rod, bearing, pressure head, processed mobile table, safety grating, start button, emergency stop Buttons, main switch power supply, operating touch screen, drive control, operating button box, electric control box, placing shock-proof foot cups on the ground, and after all the materials are prepared, the production of the press can be started.

2. Manufacturing method

The anti-vibration foot cup is installed on the base, and the base can be placed flat on the ground without shaking, and then the frame is installed; the frame is provided with a pressure head, an upper worktable and a lower worktable; the pressure head is movably set above the upper worktable, and the pressure head is connected to the guide rod , the guide rod is connected to the ball screw; the ball screw and the motor are connected by a synchronous belt drive; there is a pressure sensor on the pressure head, and the pressure sensor is electrically connected to the control panel; the right end of the control panel is provided with a start button and an emergency stop button from top to bottom. and reset button; the middle position of the upper worktable is provided with a lower backing plate, and the lower backing plate is provided with a positioning block; the left and right ends of the lower worktable are provided with supports, and each support is fixed with a press-fitting cylinder to press The mounting cylinder is connected to the piston, and the end of the piston rod is provided with a guide sleeve; the press-fitting cylinder is electrically connected to the motor; the middle position of the lower worktable is provided with a clamping mechanism, which is connected to the handwheel through a screw, and the pressure can be adjusted according to Processing requires replacement of parts, and has wide applicability.

3. Matters needing attention

The press is a precision high-end intelligent press-fitting equipment. In order to highlight the characteristics of the press, it is necessary to pay attention to the guide post, bearing, and mobile worktable for polishing and electroplating treatment. Do not scratch during production. You can wear gloves. Do a good job of lubricating the connection parts, maintain the environmental hygiene of the production site, and detect the assembly tolerance of the parts in time. As long as the above steps are followed, I believe that a press can be easily made. This article is from the official website of the manufacturer WORLD Press Machine www.pressmachine-world.com, please indicate the source for reprinting!